( 2) On Windows Server 2019, Windows Server, version 1803 or newer, Windows Server 2016, or Windows Server 2012 R2, Microsoft Defender Antivirus doesn't enter passive mode automatically when you install a non-Microsoft antivirus product. Microsoft Defender Antivirus must be disabled (manually) Microsoft Defender Antivirus must be set to passive mode (manually) The following table summarizes the state of Microsoft Defender Antivirus in several scenarios. Whether the endpoint is onboarded to Defender for Endpoint.Whether Microsoft Defender Antivirus is the primary antivirus/antimalware solution on the endpoint.Which version of Windows is installed on an endpoint.Whether Microsoft Defender Antivirus runs in active mode, passive mode, or is disabled depends on several factors, such as: In general, Microsoft Defender Antivirus can be set to passive mode only on endpoints that are onboarded to Defender for Endpoint. If the device is onboarded to Microsoft Defender for Endpoint, you can use Microsoft Defender Antivirus in passive mode as described later in this article. Restart your server to finish removing Microsoft Defender Antivirus. ( 1) On Windows Server, if you're running a non-Microsoft antivirus product, you can uninstall Microsoft Defender Antivirus by using the following PowerShell cmdlet (as an administrator): Uninstall-WindowsFeature Windows-Defender. The following table summarizes what to expect: Windows versionĪ non-Microsoft antivirus/antimalware solution In general, Microsoft Defender Antivirus does not run in passive mode on devices that are not onboarded to Defender for Endpoint. This section describes what happens when you use Microsoft Defender Antivirus alongside non-Microsoft antivirus/antimalware products on endpoints that aren't onboarded to Defender for Endpoint.
0 Comments
Leave a Reply. |